Welcome to the website of Wuxi Lanling Plastic Machinery Co., Ltd.!
Home | Contact | Sitemap
Focus on PVC Edge Band Production Line from ColorMatching, Mixing, Extruding, Design Printing and Rewinding
SERVICE HOTLINE:400-998-5355
Product navigation
Online customer service
QQ customer service
WeChat customer service

Scan QRcode

Contact Details
Janny Ni:+86 13861695773
email:78414909@qq.com
Recommended products
Position: Home>News>Common problems of extruder and the method to deal with screw heating
Common problems of extruder and the method to deal with screw heating
Common problems of extruder and the method to deal with screw heating
News Source: | Release Time:2020-07-21

挤出机常见问题及处理方法之螺杆发热现象。

1、绞刀严重磨损。绞刀与泥缸内壁的间隙太大,或绞刀叶片的螺旋角不对,应该在更换绞刀时应注意保持其间隙为3~5mm,以及应按照设计的角度制作绞刀叶片。

2、 绞刀叶片的表面过于粗糙,泥料和叶片的摩擦力太大,因此在堆焊绞刀时不要成组堆焊,一次全部换完,应循序渐进,分批更换,以确保顺利出砖。

3 、泥缸壁衬套严重磨损。绞刀叶片与泥缸壁间间隙过大,导致泥料在泥缸里的旋转运动太多,泥料出不来,也进不去。这时应更换新的泥缸衬套,或在其衬套内壁装上若干根平行或倾斜于轴向的肋条,以代替被磨掉的来复槽,阻止泥料无效的回转,增加其有效的挤出。

4 、压泥刀板与绞刀的间隙过大压不下泥料,此时应调整或补焊、更新刀板,使其与绞刀叶片的间隙小于10mm。

无锡市兰陵塑机有限公司是专业生产塑料挤出机、包线机、电线机系列产品的企业。我们拥有经验丰富的技术队伍,先进的设计手段使我们产品质量不断提高。

©2019 Wuxi Lanling Plastic Machinery Co., Ltd copyright